Flip video camera mount
The Reset Button is used to reset the camera to factory defaults. The switch should be connected to a LAN running DHCP services and the UniFi Protect Controller software. The Ethernet Port is a 10/100 Mbps port used to supply power from a PoE 802.3af-compliant switch to the camera. Useful if mounted on a wall or other permanent surface.
Flip video camera mount upgrade#
This usually indicates that a process such as a firmware upgrade is taking place.Ĭonnected to UniFi Protect Controller Reset Button PressedĪllows you to change the viewing angle of the camera by adjusting left or right. The ETH-SP-G2 will absorb power surges and safely discharge them into the ground.ĭiagram Showing Use of Ethernet Surge Protectors Hardware Overviewĭevice is busy do not touch or unplug it. We recommend that you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the UVC-G3-Flex and the other at the entry point to the building. Surge protection should be used for all outdoor installations.For more details, visit ui.com/toughcable We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. Shielded Category 5e (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE.Mount the camera in the upright position only.Mounting location should be at least 60 cm (2 ft) from the edge of the eave or ceiling.IMPORTANT: When installed outdoors, the camera must be installed in the upright postion only. This will prevent unnecessary tension on the cable ends during installation. Note: When using the Outdoor Cover, use an Ethernet cable without a strain-relief boot on the connector. Drill and 6 mm (1/4") bit for drywall anchors and 3 mm (1/8") for screws).